Motorola LI2208 Product Reference Manual page 31

To connect the USB interface:
Attach the modular connector of the USB interface cable to the host port on the bottom of the linear imager.
1.
Plug the series A connector in the USB host or hub, or plug the Power Plus connector in an available port
2.
of the IBM SurePOS terminal.
Select the USB device type by scanning the appropriate bar code from
3.
The interface cable automatically detects the host interface type and uses the
NOTE
the default (*) does not meet your requirements, scan another host bar code.
On first installation when using Windows, the software prompts to select or install the Human Interface
4.
Device driver. To install this driver, provided by Windows, click Next through all the choices and click
Finished on the last choice. The scanner powers up during this installation.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
If problems occur with the system, see Troubleshooting on page
USB INTERFACE
USB Device Type on page
12-4.
3 - 3
3-6.
default setting. If