Assemble The Stand - MasterCraft 055-6737-2 User Manual

V. Assembly and adjustments(continued)
WARNING: DO NOT CONNECT THE PLUG TO THE OUTLET UNTIL ALL INSTALLATIONS
AND ADJUSTMENTS HAVE BEEN COMPLETED AND YOU HAVE READ AND
UNDERSTOOD THE SAFETY AND OPERATIONAL INSTRUCTIONS.
ASSEMBLE THE STAND (FIG.1)
1. Unpack all of the parts, and group them by type and size (see Fig.1). Refer to the parts list for
correct quantities.
2. Attach one long top leg bracket (6) to the top of one leg (2) using a bolt (3) and a nut (4).
NOTE: Do not tighten the bolts until the stand is properly aligned (see step #8).
3. Attach other end of the long top leg bracket to top of another leg using a bolt and nut.
4. Attach ong one long bottom leg bracket (7) to the centre of each leg using bolts (3) and nuts
(4).This completes the front frame section.
5. Assemble the rear frame section in exactly the same manner.
6. Join the front and rear frame assemblies to the two short upper supports (1) and two short
bottom supports (5)using bolts and nuts.
7. Insert the rubber foot (8) into leg.
8. Place the stand on a level surface, and adjust it so that all of the legs are contacting the floor,
and are at similar angles to the floor. Tighten all of the bolts.
NOTE: The stand should not rock after all of the bolts have been tightened.
Fig. 1
9
10
11
6
2
4
7
3
1
8
5
10