To Assemble The Stand; Unpacking - MasterCraft 055-6742-8 Instruction Manual

20
model no. 055-6742-8 | contact us 1-800-689-9928
No. Description
9 Hex bolts M5 x 8
10 Stand extension poles
Pole locking knobs with stand washers,
11
hex bolts M6×50
TOOLS NEEDED FOR ASSEMBLY
Screwdriver
Star-head screwdriver
Wrench

UNPACKING

Do not use this product if any parts of the package contents are already assembled to your product when you
unpack it. Package contents are not assembled to the product by the manufacturer and require customer
installation. Use of a product that may have been improperly assembled could result in serious personal injury.
• Carefully remove the table saw from the carton and remove the protective polyfoam around the motor.
• Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
Qty Illustration
2
2
4
Framing square
Triangle square
• Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
• The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures explained in this manual.
• If any parts are damaged or missing, please call 1-800-689-9928 for assistance.
TO ASSEMBLE THE STAND (Fig. 2-5)
ASSEMBLE THE RUBBER LEVELLING PAD AND STAND EXTENSION POLES (Fig. 2-3)
• Open and place the stand assmbly on a level surface.
• Attach the rubber levelling pad (1) to the end of the
wider leg set by securing the screw (2).
• Attach the stand extension poles (3) to the narrower
and wider leg sets at the inner side, by securing
hex bolts (4), stand washers (5) and pole locking
knobs (6).
WARNING!
If any parts are damaged or missing, do not operate this tool until the parts are replaced. Use of
this product with damaged or missing parts could result in serious personal injury.
• Do not attempt to modify this tool or create accessories not recommended for use with this tool.
Any such alteration or modification is misuse and could result in a hazardous condition leading
to possible serious personal injury.
• Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
• Risk of injury! Always pull out the mains plug (disconnect the product from its power supply)
before commencing work on the product.
2
1
Fig. 2
6
5
4
3
Fig. 3
21