Assembly And Adjustments - MasterCraft 055-6737-2 User Manual

V. Assembly and adjustments
UNPACKING
1. Carefully remove the table saw from the carton.
2. Separate the parts.
3. Lay out all of the parts, and check them against the parts listed below. Examine all of the parts
carefully.
WARNING:
• IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG IN THE TABLE SAW UNTIL
YOU HAVE REPLACED THE MISSING OR DAMAGED PARTS. CALL THE TOLL FREE
HELPLINE AT 1-800-689-9928 FOR MORE INFORMATION.
• TO AVOID INJURY, THE STYROFOAM BLOCK SHOULD BE REMOVED BETWEEN
THE MOTOR AND THE TABLE.
Table saw assembly
Rip fence
Blade
wrenches
Right table
extension fence
Long top leg
brackets
Rear table extension
tubes
Locating seats
Dado table insert
Push sticker
Short bottom Long bottom
leg brackets leg brackets
Blade guard and
splitter
Flat washers
and dome nuts
Mitre gauge
Hex key
Stand legs
9
Hex bolts Batteries
Left table
extension fence
Rear table
extension
Short top leg
brackets