Replacing The Work Clamp Crank And Work Clamp Plate Holder - Brother KE-434C Instruction Manual

17. MAKING THE FEED PLATE AND WORK CLAMP PLATE FOR INNER CLAMPING DEVICE

17-5. Replacing the work clamp crank and work clamp plate holder

For Condition 2 and Condition 3, the work clamp crank and work clamp plate holder must be replaced.
2639Q
1. Remove the screw (1), and remove the work clamp crank (3) from the work clamp crank holder (2).
2. Remove the screw (4) to replace the work clamp plate holder (5) with the optional one, and install it with the screw (4).
3. Insert the work clamp crank (6) into the work clamp crank holder (2). Then while pulling out the reversal cylinder piston rod
(7) (Fig. 1), set the work clamp crank (6) so that it faces as shown in the illustration, align its groove with the washer (8), and
then tighten the screw (1) to secure it.
72 KE-434C,435C
Fig. 1
2640Q