How To Make The Work Clamp Plate - Brother KE-434C Instruction Manual

17. MAKING THE FEED PLATE AND WORK CLAMP PLATE FOR INNER CLAMPING DEVICE

17-4. How to make the work clamp plate

Condition 1
2634Q
2637Q
[Condition 1]
1. Align the stitch with reference point D which is 11 mm above the center of the screw hole in the work clamp plate.
2. Make the work clamp plate so that it is 1.5 mm smaller than the size of the seam.
3. Make a 1 mm bevel all along the side of the work clamp plate that does not have a ridge line.
[Condition 2]
1. Align the stitch with reference point E which is 9 mm above the center of the screw hole in the work clamp plate.
2. Make the work clamp plate so that it is 1.5 mm smaller than the size of the seam.
3. Make a 1 mm bevel all along the side of the work clamp plate that does not have a ridge line.
4. Then make a step of 0.5 mm as shown in the illustration.
[Condition 3]
1. Align the stitch with reference point F which is 6 mm above the center of the screw hole in the work clamp plate.
2. Make the work clamp plate so that it is 1.0 mm smaller than the size of the seam.
3. Make a 1 mm bevel all along the side of the work clamp plate that does not have a ridge line.
4. Then make a step of 0.5 mm as shown in the illustration.
Condition 2
2635Q
Work clamp
KE-434C,435C
2636Q
Condition 3
2638Q
71