7.2 Settings; Communication Port Setting (Com Port Setting) - JRC JMA-9172-SA Instruction Manual

7.2
SETTINGS
This section describes the electrical adjustment procedures to be performed by
service engineers during system installation.
7.2.1

Communication Port Setting (COM Port Setting)

External sensor signals are input to the radar equipment through a communication
port. The radar equipment has ten communication ports. For signals to be input
from sensors or to be output to the sensors, communication ports need to be set in
accordance with the sensors.
7.2.1.1 Baud Rate Setting (Baud Rate)
Set the baud rate of the signal to be input to the COM port.
Procedures
1) Open the Serviceman Menu.
2) Perform the following menu open procedure to open the Baud
Rate setting menu.
→
>
JMA-9172-SA Instruction Manual
• Do not carry out the adjustments of the equipment
except authorized service persons. If wrong setting is
carried out, this may cause unstable operation.
• Do not carry out the adjustments during navigation.
Otherwise, the radar performance may be affected,
resulting in an accident or trouble.
2. Installation Menu
5. COM Port Setting
→ 1. Baud Rate
7－ 11
7.SETTINGS FOR SYSTEM OPERATION
>

7.2 SETTINGS

7