JRC JMA-9172-SA Instruction Manual page 182

JMA-9172-SA Instruction Manual
3.7.6.4 Displaying bearing distance to the Waypoint (Status of Origin/DEST)
Select a start point used to display bearing/distance in the Waypoint data display area.
Procedures
1) Open the Next menu by performing the menu operation below.
Left-click the set value of the
2)
select an operation mode.
3.7.6.5 ON/OFF of Waypoint number display (WPT Number Display)
Set whether to display a Waypoint number next to the Waypoint mark.
Procedures
1) Open the Next menu by performing the menu operation below.
Left-click the set value of the
2)
select an operation mode.
> >
3.BASIC OPERATION 3.7 USE ROUTE FUNCTION
Route
→ 2. WPT/Route Setting
→
9. Next
:The bearing distance from the own ship position
From CURR POSN
to next Waypoint is displayed.
:The bearing distance from the previous Waypoint
Fix
to next Waypoint is displayed.
Route
→ 2. WPT/Route Setting
→
9. Next
: The Waypoint number is not displayed.
Off
: The Waypoint number is displayed.
On
3－ 86
3. Status of Origin/DEST
4. WPT Number Display
item, and
item, and