JRC JMA-9172-SA Instruction Manual page 341

7.2.1.3 Reception Sentence Setting (RX Sentence)
Set signal sentences to be received from sensors.
The system is factory-set for using all sentences. To receive only specified
sentences, select
Procedures
1) Open the Serviceman Menu.
2) Perform the following menu open procedure to open the RX
Sentence setting menu.
→
3) Select the sentences to be used by the sensors to be set.
Selection value:
1. GPS(LL/COG/SOG)： GGA/RMC/RMA/GNS/GLL/VTG
2. GPS(WPT/Time)：
3. Depth：
4. Wind：
5. Current：
→ Data Set Number： 0-9. Set the number of the sentence to be used by Data
6. Autopilot：
>
JMA-9172-SA Instruction Manual
No Use for sentences which are not necessary.
2. Installation Menu
5. COM Port Setting
→ 3. RX Sentence
No Use
Use
or
GGA/RMC/RMB/BWC/BWR/ZDA
DPT/DBK/DBT/DBS
MWV/MWD
Set Number. (Initial value 0)
→ Layer A： Set the number of the sentence to be used with layer A
by Layer Number. (Initial value 3)
→ Layer B： Set the number of the sentence to be used with layer B
by Layer Number. (Initial value 4)
→ Layer C： Set the number of the sentence to be used with layer C
by Layer Number. (Initial value 5)
APB
7－ 13
7.SETTINGS FOR SYSTEM OPERATION
can be set for each sentence.
>
7.2 SETTINGS
7