Setting Of Ccrp (Ccrp Setting) - JRC JMA-9172-SA Instruction Manual

JMA-9172-SA Instruction Manual
4) Select the setting that matches the antenna height measured in
step 1).
7.1.9

Setting of CCRP (CCRP Setting)

Set the own ship's CCRP location, radar antenna installation location, and GPS
installation location.
CCRP： Up to four locations can be input. (One location selected when used)
Radar antenna: Up to eight radar antennas can be input. (Automatically selected in
Procedures
1) Measure the CCRP location, radar antenna location, and GPS
antenna location in advance.
2) Open the Serviceman Menu.
3) Perform the following menu open procedure to open the CCRP
Setting menu.
4) Specify the ship length for Length at the upper right of the CCRP
Setting Menu, and the ship width for Beam.
5) Move the cursor onto the
input the CCRP1 location.
When X > 0, the CCRP is on the starboard side of the ship.
When X < 0, it is on the port side.
6) To input the second CCRP, click the
CCRP2 X,Y value, and input the value in the same manner for
step 5).
Similarly, input the third and subsequent CCRPs.
7) Repeat the above steps to input the GPS location(s) and radar
antenna location(s).
>
7.SETTINGS FOR SYSTEM OPERATION
response to ISW operation)
GPS： Up to four locations can be input. (One location selected when used)
2. Installation Menu
→ 4. CCRP Setting
>
7.1 SETTINGS AT INSTALLATION
CCRP1 X, Y value, and left-click to
CCRP2
7 － 8
button to display the