HOW TO SETUP
HOW TO ADJUST HEADREST & HASSLE FREE HARNESS™
A. Loosen the harness straps before adjusting the Headrest.
B. You do not need to remove the restraint from the vehicle to adjust the harness or Headrest
positions. Small adjustments maybe possible with the baby still in the seat.
C. To adjust the Headrest, pull on the latch on the back of the restraint and pull up or down to position
the top of the shoulder strap slot above the baby's shoulders. Release the latch to lock the headrest
in position. Pull headrest upwards to check it is locked in position.
Pull
(Harness straps not shown for image clarity)
IMPORTANT:
Ensure harness and Headrest are positioned so that the shoulder straps are just above the
baby's shoulders but no lower.
14
Latch
INSTALLING INTO VEHICLE (REARWARD FACING)
The restraint is normally packaged in the fully upright child use
mode so if you need to use it for baby use you must first fully
recline the restraint, and then convert the restraint to baby use
mode as shown below.
If Upper Anchorage Strap is folded up for storage undo
Storage Strap then lengthen. Fully press Adjuster Button (A)
while pulling Upper Anchorage Strap (B) to lengthen.
CONVERT TO BABY USE MODE
A. To fully recline the restraint in Child use mode, place one
hand on the front corner of the base firmly, push recline
latch up to unlock, continue pulling restraint forward
until fully reclined.
B. Once fully reclined in Child use mode, pull the latch
located behind the restraint body, continue pulling the
restraint forward until fully reclined into baby use mode.
HOW TO INSTALL
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
A
B
Storage
Band
Lift Recline Latch
15