HOW TO INSTALL
F. Engage seat belt buckle & tongue and
tighten the seat belt allowing the sash to
fully retract.
NOTE: Seat belt buckle and tongue must
not rest between restraint cover and
restraint. If seat belt buckle is adjustable,
adjust buckle as low as possible away
from the restraint.
G. Replace the centre panel properly,
ensure the harness buckle is through the
panel, and connect the hook and loop
to retain the cover. Then place back the
Headrest trim end along the Headrest.
For smaller babies replace the Insert
Pad (if fitted). Do not use if the child's
shoulders reach the lower Shoulder
Height Marker. See page 13 for advice
on positioning the shoulder straps.
NOTE: Seat belt extenders should not be
used if the seat belt is not long enough
to secure the child restraint. If they are
used then the buckle must not enter the
seating zone.
18
Pass buckle tongue through slot here
G
H. Align restraint centrally to the chosen
seating position as shown right. Pull
sash portion of seat belt until all
slack is removed from Lap portion of
seat belt. Adjust seat belt to hold the
restraint firmly against the vehicle seat
back. For retractor seat belts, allow
excess belt to feed back into retractor.
Lock the rear facing seat belt lock-off
(if fitted) to prevent the seat belt
slackening.
HOW TO INSTALL
19
C