Britax 7300 A 2010 Instructions For Installation & Use page 14

HOW TO USE
CAUTION: A LOOSE HARNESS IS DANGEROUS.
Make sure that nothing is obstructing harness straps and that
baby's arms and legs are free with the straps in the correct
location as shown right. Do not wrap the baby in a blanket or any
other wrap.
Do not use restraint if straps do not tighten and contact Britax
Childcare Customer Service. Refer to back cover for details.
IMPORTANT:
The Insert Pad is designed to snugly
support baby for extra support and comfort and must be used for
smaller babies. Discontinue use when Baby Insert Pad is a tight
fit, creates discomfort for larger babies, or the baby's shoulder
reach the Lower Shoulder Height Marker or the baby is over 6
months of age.
26
Pull to remove slack
from harness straps
REMOVING BABY FROM RESTRAINT
A. Press the Upper Anchorage Strap Adjuster Button while pulling Upper Anchorage Straps to slacken.
Allow the Upper Anchorage Straps to fall to the sides for easy access into restraint.
B. Lift and hold the harness adjustment lever or push and hold the Harness Adjustment Button
(whichever is fitted) while pulling both Shoulder Harness Straps to slacken harness to the desired
amount.
C. Press the red button on Harness Buckle. Then both Harness tongues will be released. Move each
shoulder strap to baby's side then pick up the baby.
TO REMOVE RESTRAINT FROM VEHICLE
A. Disengage seat belt tongue from buckle and remove from
the restraint.
B. Fully press the Upper Anchorage Strap Adjuster Button (1)
while pulling the Upper Anchorage Strap (2) to slacken
as shown right. In some vehicles loosening of the Upper
Anchorage Strap may be difficult. If so, try pushing the
restraint against the vehicle seat back or slightly lifting the
restraint to release the tension.
C. Disengage Attachment Clip from the Anchor Fitting. The
child restraint is now disconnected.
See page 34 for storage of the stabilising bar and the
return to the upright position if required.
HOW TO USE
Fully press Adjuster Button (1)
while pulling Upper Anchorage
Strap (2) to lengthen.
1
2
Storage
Band 3
Pull Adjustment
Strap to remove
slack
27