Britax 7300 A 2010 Instructions For Installation & Use page 12

HOW TO INSTALL
IMPORTANT:
If using an Extension Strap, positioning the Attachment Clip above the baby may lead to injury in an
accident therefore make sure that the Attachment Clip is not positioned in front of the vehicle seat.
Attachment Clip should
not be in front of the
vehicle seat front.
22
Attachment Clip
should be behind
the front of the
vehicle seat.
Extension
Strap
Attachment Clip
ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than others. If the angle of the seat causes the baby to
be too upright for comfort, the angle may be altered by placing a firm packing between the seat and
the underside of the base. Packing can be a firmly rolled up towel or nappy.
If the car's seat is flat then some packing may be required at the front edge of the Base to achieve the
recline angle.
Do not remove all of the rearward slope by over packing. Always leave a rearward slope angle of
approximately 10 to 15 degrees as shown
10° to 15°
HOW TO INSTALL
23