Table of Contents
Advertisement
HOW TO INSTALL
INSTALLING INTO VEHICLE FORWARD-FACING
(UPRIGHT OR RECLINED)
A. Remove the seat from the vehicle by
disengaging the seat belt and upper
anchorage strap.
B. Remove the Insert Pad (if fitted) as
this is no longer required.
C. To store the Stabilising Bar, lift the
cover at the end of the seat which
uncovers the stabilising bar storage
recess.
D. Press the button on the left side
(facing seat) and gently push
stabilising bar back and then down
into the recessed area.
E. Re-attach the cover at the end of
the seat.
IMPORTANT:
DO NOT USE RESTRAINT IN FORWARD-FACING POSITION WITH THE STABILISING
BAR PULLED OUT.
Do not recline into baby position when using restraint in forward-facing child use mode.
Ensure the harness is in the correct position (Refer to pages 32).
34
Hook and Loop
attachment
Stabilising
bar
Rotate
backwards
Then push
inwards
Button under trim
F. Position the restraint in forward-facing
mode and align restraint centrally within the
chosen seating position.
Some vehicle seat fabrics (particularly
velours) may be damaged by a child
restraint used continuously. We recommend
the use of a full Messy Mat™or thick towel
to keep the vehicle seat in good condition.
G. Fully lengthen seat belt. Insert seat belt
tongue through the child use seat belt path
(yellow path), ensuring that the seat belt is
behind the harness straps and that the lap
part of the seat belt is below the hooks as
shown.
H. Engage the seat belt buckle and tongue,
ensure to remove all slack from the lap part
of the seat belt 1 by pulling sash belt 2.
I. Grasp the sash belt 2 between thumb and
fingers in each hand and allow some slack
in the belt. Now slide the slack belt up into
the lock-off slot, up to the top of the slot.
If the belt is not slack it will not enter the
lock-off slot.
J. Pull the sash belt 2 through the lock-off to
fully tighten the seat belt. The sash belt 2
must not be tight when feeding it into the
lock-off slot. The child restraint should now
be firmly fitted to the vehicle seat.
Allow the excess sash belt to feed back into
retractor.
HOW TO INSTALL
2
Pull sash portion
of seat belt to
remove slack
1
Lap Seat Belt
H
Slacken the sash
belt and feed into the
lock-off
Ensure lap part of
seat belt is below
I
the hooks
Pull the sash belt
through the lock-off
to fully tighten the
seat belt
J
35
Hide quick links:
Advertisement
Table of Contents
