Charging Spare Batteries; Removing The Main Battery - Motorola MC909X Integrator Manual

Charging Spare Batteries

CAUTION Ensure that you follow the guidelines for battery safety described in
10-1.
Use the following three accessories to charge spare batteries:
•
Single Slot Serial/USB Cradle
•
Four Slot Spare Battery Charger
•
UBC Adapter.
To charge a spare battery:
Ensure the accessory used to charge the spare battery is connected to the appropriate power source (see
1.
Chapter 2, Accessories
Insert the spare battery into the accessory's spare battery charging slot with the charging contacts facing down
2.
(over the charging pins) and gently press down on the battery to ensure proper contact.
The battery starts to charge automatically. The amber charge LED on the accessory lights to show the charge
3.
status. See Chapter 2, Accessories
The battery usually fully charges in less than four hours.

Removing the Main Battery

To remove the main battery:
Prior to removing the battery, press the red Power button to place the mobile computer in the suspend mode.
1.
For the MC9097, wait 10 seconds before proceeding to the next step. If you do not, you may need to perform a
2.
warm boot after replacing the battery.
Press the primary battery release(s). The battery partially ejects from the mobile computer.
3.
Pause three to four seconds while the mobile computer performs battery removal shutdown.
4.
Press the secondary battery release, on top of the battery, and slide the battery out of the mobile computer.
5.
for setup information).
for charging indications for the accessory.
Getting Started
Battery Safety Guidelines on page
1 - 9