Trace Route Window; Known Aps Window - Motorola MC909X Integrator Manual

4 - 32 MC909X Integrator Guide
From the
2. Size
Tap . The ICMP Ping test starts. Information of the ping test displays in the appropriate fields.
3. Start Test

Trace Route Window

traces a packet from a computer to a host, showing how many hops the packet requires to reach the
Trace Route
host and how long each hop takes. The
The window allows testing a connection at the network layer (part of the IP protocol) between the
Trace Route
mobile computer and any place on the network.
To open the
Trace Route
Trace Route Window
Figure 4-45
Enter an IP address or a DNS Name in the IP combo box, and tap
information shown in the
all routers between the mobile computer and the destination. The Round Trip Time (RTT) between the mobile
computer and each router appears, along with the total test time. The total test time may be longer than all RTTs
added together because it does not only include time on the network.

Known APs Window

The window displays the APs in range using the same ESSID as the mobile computer. This window is
Known APs
only available in
Infrastructure
window.
drop-down list, select a size value.
Trace Route
window, tap
Trace Route
window's IP combo box. When starting a test, the trace route attempts to find
ICMP Ping
mode. To open the
utility identifies where the longest delays occur.
in the
Wireless Diagnostics
Start Test
window, tap
Known APs Known APs
window.
. The IP combo box should match the
in the
Wireless Diagnostics