Charging Spare Batteries; Charging Temperature; Powering On The Fr68 Series; Calibrating The Screen - Motorola FR68 Series User Manual

The 1950 mAh battery is fully charged in less than four hours, and the 3600 mAh battery, in
approximately six hours.
LED Charge Indicators
Table 1-2
Charging/Battery
Status LED
Off
Slow blinking amber
Solid green
Fast blinking red
Single blinking amber
(when device is turned on)
Fast blinking amber

Charging Spare Batteries

See Chapter 8, Accessories

Charging Temperature

Charge batteries in temperatures from 0°C to 45°C (32°F to 113°F). Charging is intelligently controlled
by the FR68 Series.
To accomplish this, for small periods of time, the FR68 Series or accessory alternately enables and
disables battery charging to keep the battery at acceptable temperatures. The FR68 Series or
accessory indicates when charging is disabled due to abnormal temperatures via its LED. See
1-2 on Page 20.

Powering On the FR68 Series

Press the Power button to turn on the FR68 Series.
When turning the FR68 Series on for the first time, the splash screen displays for about a minute as
the FR68 Series initializes its flash file system, then the calibration window appears.

NOTE When the FR68 Series powers up after inserting a battery for the first time, the device boots and
powers on automatically.

Calibrating the Screen

To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
Remove the stylus from its holder on the back of the FR68 Series.
1.
Carefully press and briefly hold the tip of stylus on the center of each target that appears on the
2.
screen.
Indication
FR68 Series is not charging.
FR68 Series is not inserted correctly in the cradle or connected to a
power source. Charger/cradle is not powered.
FR68 Series is charging.
Charging complete.
Note: When the battery is initially inserted in the FR68 Series, the amber
LED flashes once if the battery power is low or the battery is not fully
inserted.
Charging error, e.g.:

Temperature is too low or too high.

Charging has gone on too long without completion (typically eight
hours).
Battery depleted.
Battery over-temperature condition.
for information on using accessories to change spare batteries.
20
Getting Started
Table