Setting Time Periods - Sanyo DSR-3506 Instruction Manual

2 INITIAL SET

Setting time periods

A time period is setup by the two timers TIME PERIOD A
and TIME PERIOD B, and the following procedure can be
used to specify four different periods per day based on
time period settings (for instance, early morning, morning,
lunchtime, and night). For example, it is possible to set
TIME PERIOD A for automatic screen selection and the
period between TIME PERIOD B for the masking of
monitor video using a gray pattern.
Morning to lunchtime: 6:00 to 11:00
Cameras No. 2, 3, and 5 are masked.
01 02
04 05
Lunchtime: 11:00 to 13:00
Cameras No. 1, 4, and 6 are masked.
02
01
04 05
Lunchtime to night: 13:00 to 20:00
Cameras No. 1, 2, 5, 6 automatic selection is carried out.
01
02
Night to morning: 20:00 to 6:00
Cameras No. 1, 3 and 4 automatic selection is carried out.
01
03
03
06
03
06
05
06
04
Operations during the specified time periods
The following menu settings must be made to enable
operation of the time periods. After completing these
settings, be sure to then carry out timer setting.
Setting automatic selection of camera video
Set which automatically selected camera to display video
from and the switching interval.
To do this, set "SEQUENCE SET" from <SCREEN SET>.
( P.88)
Masking camera video using a gray pattern
Use "MASK SET" from <SCREEN SET> to specify which
cameras are to be displayed on the monitor and which are
not. ( P.91)
Alarm recording using motion sensors
To detect camera alarms, set "MOTION SENSOR" from
<ALARM REC MODE SET>. ( P.72)
50
English