Setting The Security Lock - Sanyo DSR-3506 Instruction Manual

4 GENERAL SET

Setting the security lock

Use the procedures described below to set a passwords
and to prevent unauthorized users from operating the
digital video recorder. If a button is pressed while the
security lock is in operation, a buzzer will be sounded. Be
sure to make a note of the passwords that are set.
Operation after setting passwords
Two password types can be set, one for administrators
and one for users. The table below gives typical
password setting combinations and lists how the digital
video recorder operates for each.
Typical setting
LEVEL PASSWORD (4 - 8)
ADMIN 123456AB
USER AB123456
REC CONTROL
ADMIN 123456AB
USER AB123456
REC CONTROL
ADMIN 123456AB
USER --------
REC CONTROL
ADMIN 123456AB
USER --------
REC CONTROL
ADMIN --------
USER --------
REC CONTROL
ADMIN --------
USER --------
REC CONTROL
An administrator password will be required when
initializing the hard disk, setting recording areas, or
performing an "AREA FULL RESET". The default
setting for this password is "0000".
English
Operation
USE All operations are locked.
ON
Enter the user password
ON
to enable playback
: ADMIN
operations.
Enter the administrator
password to enable all
operations.
ON All operations are locked.
ON
Enter the user password
: USER
to enable playback and
recording operations.
Enter the administrator
password to enable all
operations.
ON Recording and menu
OFF operations are locked.
: ADMIN Playback operations are
locked.
Enter the administrator
password to enable all
operations.
ON Recording and menu
OFF operations are locked.
: USER Playback operations are
locked.
Enter the administrator
password to enable all
operations.
OFF
This setting cannot be
ON
carried out.
: ADMIN
OFF All operations are
OFF possible.
: ADMIN The security lock is not
activated.
(Default setting)
Setting the administrator password
Passwords comprise between 4 and 8 alphanumeric
characters.
Characters that can be entered in passwords: 0 to 9, A to Z
Example: Setting "123456AB" as a password
1
Press the [MENU] button and turn the
jog dial to select "3. GENERAL SET",
and then turn the shuttle dial clockwise.
The <GENERAL SET> screen is displayed.
MENU
2
Turn the jog dial to select "3. SECURITY
LOCK SET", and then turn the shuttle
dial clockwise.
The <SECURITY LOCK SET> screen is displayed.
The cursor moves to "ADMIN".
3
Turn the shuttle dial clockwise.
The first password character "-" flashes.
ADMIN --------
4
Turn the jog dial to select a character (0
to 9, A to Z).
Example:
Turn the jog dial to select "1".
ADMIN 1-------
5
Turn the shuttle dial clockwise.
The second password character "-" flashes.
6
Use the same procedure to set
"123456AB".
79
OFF
OFF