Adjusting The Printer For Self-Strip Printing - Intermec EasyCoder 3240 Getting Started Manual

Hide thumbs Also See for EasyCoder 3240:

Table of Contents

EasyCoder 3240 Printer Getting Started Guide

Adjusting the Printer for Self-Strip Printing

Positioning the Label Taken Sensor

3-20

If your 3240 printer is continuing to print labels even when there is a label

waiting to be removed at the strip bar, you may need to adjust the label taken

sensor. The label taken sensor detects whether there is a label present at the tear

bar. The printer uses this sensor to determine when you remove a stripped

label and when it can print the next label. You can only use this sensor with the

self-strip option.

Note: It is only necessary to adjust the label taken sensor when using very narrow

labels (less than 0.5 inch).

To position the label taken sensor

1. Slide the label taken sensor up to 3/8 inch from the inner edge of the media

path.

2. Align the label taken sensor over the leading edge of the label at the tear

bar.

Label

taken

sensor

Label

Backing

Co de 39

Tear

bar

3240G.019

Table of Contents

Do you have a question about the EasyCoder 3240 and is the answer not in the manual?