Four winns V Series Owner's Manual page 96

American Boat and Yacht Council (ABYC) standards.
See Figures H25 and H26.
To extend the Cablemaster shore power cable (if
equipped):
1) Flip the power switch to "OUT" position; grasp the
power cord plug.
2) Walk to dock power source and plug power cord
into receptacle.
3) Cablemaster will automatically shut itself "OFF"
when cable has fully extended or when the
momentary switch is released.
4) If less cable is more desirable, turn switch to the
"IN" position.
5) Release switch when desired cable length is
achieved
To retract the Cablemaster shore power cable:
1) Disconnect the power cord plug from the dock
power source.
2) While holding power plug, walk to Cablemaster.
3) Turn the power switch to the "IN" position.
4) Cablemaster will automatically shut itself off when
cable has fully retracted or when the momentary
switch is released. Do not move vessel until
cable is fully retracted!
Some marinas are not equipped with approved twist
lock-type receptacles. Use only an adaptor approved
by the manufacturer when an adaptor is necessary.
An adaptor may be available through the dockside
cable manufacturer, Marinco. Follow the manufac-
turer's instructions regarding its use.
DO NOT use a two-wire adaptor to con nect to a
three-wire system. These adaptors do not
provide adequate groun ding.
Shore power connection procedure is as follows:
1. Be sure the generator is "OFF" (if equipped).
Place the AC lockout slider over the GENERA-
TOR main circuit breakers on the AC panel.
Electrical Systems - Section H
2. Turn "OFF" the boat's main (SHORE) breaker
switch before connecting or disconnecting the
shore power cable.
3. Connect shore power cable to the dockside inlet
receptacle of the boat first, then connect it to
dockside shore power outlet. Omit this step if
equipped with Cablemaster.
NOTICE
Always con nect the cord to the shore power
inlet recep tacle of the boat before making
connec tions to the shore power source. Not
applicable for Cablemaster equipped models.
4. Connect shore power cable to dockside shore
power outlet. If equipped with Cablemaster
following procedure described earlier regarding
extended the shore power cable.
5. Check for reversed polarity on the AC panel.
If the reversed polarity light is activated, immedi-
ately discon nect the shore power cord.
See Section H-8C - Reverse Polarity Indicator.
6. Turn the SHORE main breakers at the AC cabin
panel and at the dockside outlet (if applicable) to
the "ON" position. See Figure H30.
Figure H30: Shore Power Inlet
(Representative View - Models May Vary)
To disconnect shore power:
1. Turn the main (SHORE) circuit breaker switches to
the "OFF" position located on the AC panel and at
the dockside inlet of the boat (certain models
only). See Figure H30.
Owner's Manual Page 94