Electric Toilet Operation - Four winns V Series Owner's Manual

Figure J13: Do Not Place These Items in Toilet Label
Figure J14: Porcelain Toilet - Left Hand
B. Electric Toilet Operations
1. Add water to the toilet bowl by pressing "Add
Water" switch (1) and hold until desired water level
is achieved. See Figure J15. (Do not press "Add
Water and Waste Systems - Section J
Water" switch too long or overflow may occur.)
More water is usually added only when flushing
solids.
2. To flush the toilet press the "Flush" switch (2)
down and hold for a few seconds after waste
drains from toilet bowl (about five seconds). See
Figure J15. This switch activates a powerful
macerator pump that siphons water and waste
from the bowl, macerates, and propels the effluent
through the discharge line/holding tank. To use
less water for liquid-only flushes, press "Flush"
switch for shorter period of time.
3. "DRY BOWL" OPERATION - During periods of
rough travel, water in a toilet bowl can splash out
and into the bathroom area . To avoid this situa-
tion, press "Dry Bowl" switch (3) to drain water
completely from toilet bowl. See Figure J15. Water
is not added to bowl during or after pressing the
"Dry Bowl" switch
2
Figure J15: Electric Toilet Switch
Do Not Flush Waste with "Dry Bowl" Switch!
To maintain proper cleanliness and operation of
the toilet and macerator pump, water should be
used with every flush.
Do Not Flush Foreign Objects! Flush only
water, bodily wastes and rapid-dissolving toilet
tissue. Do not flush wet wipes, sanitary
napkins, condoms, diapers, paper cups, cotton
swabs, food, hair or liquids such as oils or
solvents as clogging or damage to the toilet or
toilet system may occur.
1
3
Owner's Manual Page 125