Table of Contents
Advertisement
C. Interior/Exterior Equipment
NOTICE
The V series 12VDC electrical panels, such as
light and cabin panels, vary according to model
and equipment availabilty. The information re-
garding general activation of the 12VDC equip-
ment is however similar. If you are still experienc-
ing difficulty after reading this section, please
contact your Four Winns dealer for assistance.
To supply power to the cabin equipment on certain
models requires either turning the battery switch or the
Ship's Systems circuit breaker on the battery switch to
the "ON" position. See Figures H3, H6 & H7.
Other models require the following. If not already
done, first place the "HOUSE" battery switch (at the
battery switch) to the "ON" postion. Secondly, (de-
pending on the model) there is a cabin panel either
called "Power Management Center" or the "12VDC"
cabin panel. See Figures H15 & H16 respectively.
Turn the "HOUSE" or the "HOUSE ACTIVE" switch to
the "ON" position. Lastly if applicable, on the "12 VDC
cabin panel "there is a "CABIN MAIN" circuit breaker
switch (Figure H17). Place this switch to the "ON"
position as well. Power is then supplied to the cabin.
Note: Activation of the house battery is indicated by a
lit LED light (depending on the model) Refer also to
Figures H7-H9.
The following is a listing followed by a brief description
of the certain 12 volt cabin equipment. The equip-
ment's circuitry is protected by circuit breakers on
cabin 12VDC panel (if applicable). Additionally, certain
12 volt equipment may have an additional circuit
breaker located on another circuit breaker panel.
Note: When applicable the specific circuit breaker on
the cabin panel must also be activated (placed in the
"ON" position) in order for the desired equipment to
work.
Step Lights - If installed the STEP LTS switch (located
on the transom switch) is used to activate the step
lights at the transom and for the deck lighting in the
rail.
Transom Speakers - If installed this switch is part of
the transom switch assembly. The switch permits one
to conveniently turn the transom speakers "ON" or
"OFF" while at the transom.
Electrical Systems - Section H
Engine Room Lights - If equipped these lights are
activated automatically when either the engine hatch
or the engine inspection hatch are raised.
Fresh Water Pump - A pressure water pump deliv ers
water to the faucets, shower, and transom washd own
(if installed) The pressure water pump will oper ate
automatical ly as long as the FRESH WATER PUMP
circuit breaker switch is "ON". Turn the FRESH
WATER PUMP circuit breaker switch "OFF" when the
water tank be comes empty or when water will not be
required for an extended period or when connected to
shore water while at dockside. Tank monitoring
systems are available to check water levels. Refer to
Section J-1 and J-2 in this manual for additional
information.
Forward Bilge Pump - The forward bilge pump can be
activated manually by the FWD BILGE PUMP breaker
switch placed in the "ON" position. Any water from the
stringers or from other sourc es within the cabin will
drain into the forward bilge compartment. The pump is
equipped with an automatic float switch and will
operate when ever bilge water rises to a level that will
cause the float to move upward. The water will be
pumped over board.
Shower Sump Pump(s) - These shower sump
pump(s) are used to dis charge water from their
respective shower and sink sump(s) overboard or into
an available gray water tank (if installed). These sump
pumps have a float switch which will activate the
pump when the water level rises in the sump. The
respective pump is protected by the SHOWER SUMP
PUMP circuit breaker(s).
Galley Refrigerator/Freezer - If equipped, this refrig-
erator/freezer is a dual voltage unit and therefore has
a circuit breaker provided on both the AC cabin panel
and on the 12VDC cabin panel (if available) to provide
protection no matter which power source is being
used. The refrigerator/freezer typically has a sepa rate
"ON/OFF" switch also. Refer to Section L-1D in this
manual and to the manufacturer's literature for
additional informa tion.
Accessories - Additional 12 volt equipment may be
added to the boat by wiring directly to the cabin panel
using the existing ACCESSORY circuit breaker(s)
provided. See Section H7-B -- Installation of Additional
12 Volt Equip ment.
Salon Lights/Stateroom Lights/Aft Cabin Lights/Galley
Lights/Night Lights/Fwd Head Lights/Aft Head Lights/
Owner's Manual Page 89
Advertisement
Table of Contents
