Table of Contents
Advertisement
Figure Q4: Transom Table
(Available on Certain V series Models Only)
Q - 5 TEAK
Teak tables, cockpits and swim platforms are avail-
able on certain V series models. See Figures Q4 &
Q5.
Figure Q4: Teak Cockpit Table
Figure Q5: Teak Cockpit & Swim Platform
Before teak can be given any coating, it must be
completely cleaned. Follow the manufacturer's
directions with regard to cleaning. Once cleaning has
been accomplished there are finishes that may be
Woodwork and Composites - Section Q
applied such as teak oil (traditional), sealers, or
varnishing. Again, Four Winns recommends following
the table manufacturer recommendations. Additional
note: There are numerous teak products on the
market that may be tried that will give you the look you
desire. Your Four Winns dealer can also provide you
with some helpful suggestions.
NOTICE
DO NOT use abrasive cleaners or sol vents on
cockpit table. DO NOT use Soft Scrub™ soap
or similar cleaning prod ucts; they will scratch
the surface and remove the shine.
NOTICE
DO NOT use tables as a cutting board. The
knife will leave gouges/marks in the surface of
the table. Use an actual cutting board in order
to protect the tables.
Q - 6
SOLID SURFACE MATERIAL
Solid surface material is utilized in various countertops
found in various parts of the boat such as the galley,
cockpit refreshment center, and head to name a few.
The solid surface gives these countertops a rich look
and makes for an extremely strong yet lightweight top.
It can be cleaned with hand dish washing soap and
water. Always read the label before using any product.
See Figures Q6 - Q8.
Figure Q6: Galley Countertop
(Representative View - Models Will Vary)
Owner's Manual Page 177
Advertisement
Table of Contents
