Acrylic Plastic (Plexiglass) - Four winns V Series Owner's Manual

Figure Q7: Cockpit Refreshment Center
(Representative View - Models Will Vary)
Figure Q8: Head Sink w/ Solid Surface Countertop
(Representative View - Models will vary)
NOTICE
DO NOT use abrasive cleaners or sol vents on
countertop. DO NOT use Soft Scrub™ soap or
similar cleaning prod ucts; they will scratch the
surface and remove the shine.
Woodwork and Composites - Section Q
NOTICE
DO NOT set hot pans or dishes directly on the
countertop. The countertop may become burnt
and/or discolored. Use of a hot pad will prevent
any discoloration from occurring.
NOTICE
DO NOT use countertop as a cutting board.
The knife will leave gouges/marks in the
surface of the countertop. A cutting board that
fits over the sink is provided.
Q - 7

Acrylic Plastic (Plexiglass)

Acrylic plastic is utilized in the companionway doors,
transom doors, deck hatches, portlight windows,
skylights, sliding storage doors, electrical panel doors,
cabinets and cabin windows. See Figure Q9.
Figure Q9: Companionway Door
(Representative View - Models Will Vary)
To clean acrylic plastic:
1) Rinse with plenty of water to wash off as much
dirt as possible.
2) Using your bare hand, along with plenty of water,
feel and remove any dried on dirt or mud. Do not
use fingernails to scrape as this could scratch the
plexiglass.
3) Wash using a soft, grit free cloth or sponge and
mild, nonabrasive soap or detergent.
4) Blot dry using a clean, damp chamois.
Owner's Manual Page 178