Table of Contents
Advertisement
4. To go from FORWARD to REVERSE, or
REVERSE to FORWARD; always pause at
NEUTRAL and allow engine speed to fall below
1500 RPM.
NOTICE
On certain models, if you attempt to shift gear
at an excessive engine speed, a safety function
cuts in automatically, and delays shifting until
engine speed has fallen below 1500 RPM.
5. After shifting is completed, slowly push throttle
lever(s) forward/rearward until desired speed
is achieved.
On a boat with twin engines it is important that
both engines be running during reverse
procedures, to avoid the risk of water entry (via
the exhaust pipe) into a stationary engine.
Any time the boat is operated, be aware of
changes in shift system operation. A sudden
increase in shift effort of the shifter levers, or
other abnormal operation, indicates a possible
problem in the shift system. If this occurs, the
following precautions must be taken:
•
With engine running and boat securely
tied to the dock, shift drive into forward
and reverse to ensure there is gear
engagement.
•
When docking the boat, all docking
maneuvers must be performed at slow
speed. Pay special attention to other
boaters. Passengers should be
informed of potential problems and
precautions taken.
If you suspect there is a problem, see your engine
manufacturer's authorized service center as soon as
possible for proper diagnosis and required service or
adjustment. Continued operation could result in
damage to the shift mechanism and loss of control.
Operation - Section A
E. Stopping Engine - EFI & Diesel
1. Move shifter/throttle lever(s) to the NEUTRAL
position.
2. Turn ignition key to the OFF position.
NOTICE
DO NOT stop engine at speeds above idle or
"speed up" engine while turning off ignition.
Engine damage could result.
F. Stopping Engine for Diesel Engines with
Volvo Penta Electronic Vessel Control (EVC)
1. Move shifter lever(s) to the NEUTRAL position.
Allow engines to idle for a few minutes (in neutral)
before turning them OFF. This will avoid boiling
and even out the temperature. This is especially
important if the engines have been operated at
high engine speeds and loads.
2. Turn ignition key to the STOP position "S" Keep the
key turned until the engine stops. The key will auto-
matically return to the OFF position "0" when re-
leased and then can be removed. See Figure A7.
Figure A7: Ignition Switch STOP Position
Never switch OFF the main battery switches
while engines are running. This could damage
the alternator.
Never switch OFF the main battery switches
before the starter key is turned OFF (is in the
"0" position or removed). This could damage
the electrical system.
Owner's Manual Page 22
Advertisement
Table of Contents
