Table of Contents
Advertisement
Figure O5: Camper Side & Aft Curtain Installation
To install the camper canvas:
1) Install the bimini top as previously described.
2) Using the locator tags (if applicable), find the side
curtains. See Figure O5.
3) Starting at the top, start each zipper.
4) When aII zippers have been started,
complete zipping.
5) Snap the side curtains to the boat.
6) Smooth all velcro down (if applicable).
7) Locate the aft curtain.
8) Zip the aft curtain to the curtain top, starting
at the center.
9) Secure with a strap to the aft railing or snap to
transom.
10) Zip to port and starboard curtains.
11) Snap to boot.
12) Secure and smooth all velcro (if applicable).
For camper storage, reverse the procedure described
above.
NOTICE
DO NOT FOLD THE AFT OR SIDE CURTAINS!
Damage may result. Always roll the side and aft
curtains up to prevent damage to the isinglass
(clear plastic).
Weather Covers - Section O
This camper is designed as temporary
shelter only. It should not be left up
unattended for any extended length of
time. Violent weather could result in
expensive damage. Misuse is not
covered under warranty.
O - 5
COCKPIT COVER
The cockpit cover is available on certain V series
models and is used to cover the complete cockpit
area and is intended as a short term storage cover.
See Figure O6.
Figure O6: Cockpit Cover
(Representative View Only - Models may vary)
To install the cockpit canvas:
1) A cockpit cover is intended for short term storage
only. Do not operate the vessel with the cockpit
cover installed due to the potential for carbon
monoxide gas build-up.
2) Using the locator tag, find the center point on the
canvas and attach it to the center point of the
windshield.
3) Working outward equally in both directions,
continue snapping the canvas in position.
4) When the canvas extends far enough, separate
the velcro strips and install the cover around the
bimini support poles. Reattach and smooth out
Owner's Manual Page 164
Advertisement
Table of Contents
