Timer Recording; Vcr Plus+ Timer Programing - JVC HR-DVS3U Instructions Manual

42
EN
VCR Plus+
Programing
With the VCR Plus+ system, timer programing is greatly
simplified because each TV program has a corresponding
code number which your VCR is able to recognize.
Before performing the VCR Plus+ Timer Programing:
Make sure that the VCR's built-in clock is set properly.
Turn on the TV and select the AV mode.
1
4
7
1
Timer
®
T W
2 3
2
5 6
8 9
0
4
DV S-VHS
A
Turn on the VCR.
Press POWER.
B
Load a cassette.
Insert a VHS (or S-VHS) cassette with the record safety
tab intact.
OR
Insert a Mini DV cassette with the erase protection switch
set to "REC".
C
Select the deck.
Press S-VHS or DV.
D
Access the PlusCode No. screen.
Press PROG.
The clock must be set to access
the PlusCode No. screen. If
you have not set the clock, the
Main Menu screen appears
after an error message is
displayed. Refer to "Plug &
Play Set" ( pg. 14) or "Clock
Set" ( pg. 16).
E
Enter the PlusCode number.
Press the number keys to
enter the PlusCode number
of a program you wish to
record. Then press OK.
If you make a mistake, press
CANCEL and input the correct
number.
F
Access the VCR Plus+ Program screen.
The VCR Plus+ Program
screen appears (if you're just
starting out and you have
selected the VHS deck, "VHS
PROGRAM 1" appears).
IMPORTANT
Make sure the channel position number you wish to record is
displayed; if not, see "Changing VCR Plus+
page 44 and set the Guide Channel number correctly.
If the number you entered is invalid, "ERROR" appears on the
TV screen. Press CANCEL and input a valid PlusCode number.
If the "GUIDE CHANNEL SET" screen appears, see
"ATTENTION" on page 43.

TIMER RECORDING

Setting" on
®