JVC HR-DVS3U Instructions Manual page 75

VHS MODE SET (cont.)
VIDEO STABILIZER
8
ON
OFF
DIGITAL R3
8
ON
OFF
AUDIO MONITOR
8
HI-FI
HI-FI L
HI-FI R
NORM
MIX
When this function is set to "ON", you can automatically correct vertical vibration
in the picture when playing back unstable recordings made on another VCR.
NOTES:
When you finish viewing a tape, be sure to set this function to "OFF".
Regardless of the setting, this function has no effect during recording and during special effects
playback.
The on-screen display may jitter vertically when this function is set to "ON".
To watch recordings with close-caption, set this function to "OFF".
Video Stabilizer and Digital TBC/NR cannot be used at the same time. If you activate Digital
TBC/NR when "VIDEO STABILIZER" is set to "ON", Video Stabilizer will be automatically
turned "OFF".
When this function is set to "ON", the Digital R3 picture system applies edge
correction to the luminance signal to enhance details.
NOTES:
Normally it is recommended to keep "DIGITAL R3" set to "ON".
Depending on the type of tape being used, picture quality may be better with "DIGITAL
R3" set to "OFF".
If you use the VCR as the source player for editing, be sure to set "DIGITAL R3" to "OFF"
before starting.
This VCR can record two sound tracks simultaneously (normal and Hi-Fi) on a Hi-Fi
stereo tape. You can select the sound track(s) to listen to while playing back a Hi-Fi
stereo tape. In addition, when playing back a prerecorded tape containing two
separate audio programs on the Hi-Fi tracks, you can choose either one by
selecting either "HI-FI L" or "HI-FI R".
HI-FI: Normally select this. Hi-Fi sound is played back.
HI-FI L: Sound on the left Hi-Fi channel is played back.
HI-FI R: Sound on the right Hi-Fi channel is played back.
NORM: Sound on the normal track is played back.
MIX: Both sounds on the Hi-Fi track and normal track are mixed and
played back.
NOTES:
While playing back a monaural tape, sounds on the normal track will be heard regardless of
this setting.
You can also use the A. MONITOR button on the Remote to select the desired monitor
sound. ( pg. 31)
* The default setting is bold in the table below.
75
EN