When Programs Overlap Each Other - JVC HR-DVS3U Instructions Manual

ATTENTION
If there is a conflict in the timer schedule and one
program overlaps with another, only the parts shown
below in gray will be recorded.
Pattern 1: The program with the lower program number
will be recorded.
10:00 11:00
Program 1
CH10
Program 2
CH40
Pattern 2: The program starting earlier will be recorded.
10:00 11:00
Program 1
CH10
CH40
Program 2
Pattern 3: The program starting earlier will be recorded,
followed by the remaining portion of the other
program.
10:00 11:00
Program 1
CH10
Program 2
ATTENTION
If the program you have
just made and "DV" are
blinking, there is a
conflicting program on the
DV deck.
A Press
to move the
rt
highlight bar to "DV",
then press OK or .
e
DV Program Check
screen appears.
B Cancel or change
program setting as
described in step 2 and
3 in the right column.
12:00
Not recorded
12:00
Not recorded
12:00
CH40
Not recorded

When programs overlap each other

If "PROGRAM NOT COMPLETED PROGRAM OVERLAP"
appears, you have another program overlapping the program
you have just made.
The Program Check screen appears and conflicting programs
will start blinking.
Example: Program 1 (you have just made) and Program 4
overlap each other on the VHS deck.
A
Confirm the overlapping programs.
Overlapping programs blink on the TV screen.
B
Select the program to modify.
Press , then press OK or
rt
You can only select one of the overlapping programs.
NOTE:
If you do not mind this overlap, press PROG to finish the timer
program setting. See "ATTENTION" in the left column. The
program with the lower program number will be recorded and
the other one will not be recorded correctly. If no changes are
made for approximately 3 minute, the VCR will return to the
normal screen.
C
Cancel or change program setting.
To cancel a program, press
screen you do not want is shown. "PROGRAM
COMPLETED" appears on the TV screen for about 5
seconds, then the normal screen appears.
To change a program, press the appropriate button:
START+/–, STOP+/–, DATE+/–, CH+/–, and/or SP/EP
( ) when the Program screen on which you want to
p
make changes is shown, then press OK. "PROGRAM
COMPLETED" appears on the TV screen for about 5
seconds, then the normal screen appears.
NOTE:
If the overlap is not yet solved, or another overlap occurs with
the timer program setting after making the last correction on a
program, the conflicting programs will be shown on the Program
Check screen again. Repeat the above steps again until the
overlap is solved.
51
EN
.
e
when the Program
CANCEL