JVC HR-DVS3U Instructions Manual page 61

A
Make connections.
Connect an audio component to the AUDIO L + R input
connectors on the VCR's front panel.
When connecting a monaural audio component, use only the
VCR's AUDIO L input connector.
B
Load a cassette.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the record safety
tab intact, or cover the hole using adhesive tape.
For the DV deck
Insert a Mini DV cassette with the erase protection switch
set to "REC".
C
Set the VCR's input mode.
Press AUX (number key "0") and/or CH +/– to select
"F-1".
D
Select the recording deck.
Press S-VHS or DV.
When using the DV deck as the recording deck, press
that the audio signals from the AUDIO L + R input connectors
can be recorded. The dubbing direction indicator (
lights.
E
Locate the start point.
Press PLAY ( ) to start playback of the tape in your VCR,
4
and press PAUSE ( ) when you reach the point where
9
you want to start dubbing.
F
Engage the Audio Dubbing mode.
Press A.DUB.
Your VCR enters the Audio Dubbing Pause mode. ("
" " and " " light up on the front display panel.)
u i
G
Start dubbing.
Engage the audio component's Play mode, then press
PLAY ( ) to start the tape in your VCR; Audio Dubbing
4
begins at this point.
" " blinks and "
o
To stop dubbing temporarily, press PAUSE (
to resume dubbing.
H
End Audio Dubbing.
Press STOP (
the audio component's Stop mode.
NOTES:
Once the Audio Dubbing starts, you can not use the other
deck.
When monitoring the audio-dubbed sound on the DV deck,
set "12BIT MODE" to "SOUND2" (
When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the mixed sound (Hi-Fi + Normal soundtracks), press
A. MONITOR to select "NORM HI FI" (
deck only)
Audio Dubbing stops automatically when the counter reaches
"0:00:00", and the VCR enters the Play mode. Check the
counter reading before dubbing. (VHS deck only)
so
Audio Dubbing is also possible using the rear panel AUDIO IN
connector.
S-VHS)
When playing back an audio-dubbed tape on the VHS deck,
press A. MONITOR on the Remote to select the soundtrack
you wish to hear (
dubbed Mini DV tape on the DV deck, set "12BIT MODE" to
"SOUND2" (
Picture may be distorted during Audio Dubbing Pause.
It may be unlawful to record or play back copyrighted material
without the consent of the copyright owner.
Audio dubbing is not possible using the DV IN/OUT
connector.
Audio dubbing is not possible on a blank portion of the tape.
" blinks,
o
" is displayed on the front display panel.
u
) to stop the tape in your VCR, and engage
8
pg. 31). When playing back an audio-
pg. 76).
61
EN
). Press PLAY ( )
9 4
pg. 76).
pg. 31). (VHS