JVC HR-DVS3U Instructions Manual page 79

TIMER RECORDING
SYMPTOM
1. Timer recording won't work.
2. Timer programing is not possible.
3. " " and " " on the front display
# [
panel won't stop blinking.
4. " " blinks for 10 seconds and the
#
Timer mode is disengaged.
5. The VCR Plus+ system does not timer-
record properly.
6. The power shuts off and "
stop blinking.
The clock and/or the timer have been set
incorrectly.
The timer is not engaged.
Timer recording may not work when the
VCR's input mode is set to "F-1" for
recording on the DV deck.
Timer recording is in progress.
The timer is engaged but there's no
cassette loaded.
The end of the tape was reached during
timer recording.
VHS deck
The loaded cassette has had its record
safety tab removed.
DV deck
The loaded cassette has had its erase
protection switch set to "SAVE".
TIMER has been pressed when there are
no programs in memory, or the timer
record information has been programed
incorrectly.
The VCR's channel positions have been
set incorrectly.
" won't The end of the tape was reached during
[
Instant Timer Recording.
POSSIBLE CAUSE CORRECTIVE ACTION
Re-perform the clock and/or timer
settings.
Press TIMER and confirm that "
displayed on the front display panel.
Set the channel position other than "F-1"
before engaging to Timer-Standby mode.
Timer programing can't be performed
while a timer recording is in progress.
Wait until it finishes.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the
record safety tab intact, or cover the hole
using adhesive tape.
For the DV deck
Insert a Mini DV cassette with the erase
protection switch set to "REC".
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
Remove the cassette and set the erase
protection switch to "REC".
Check the programed data and re-
program as necessary, then press TIMER
again.
Refer to "Guide Channel Number Set"
( pg. 44) and re-perform the procedure.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
79
EN
" is
#