Optional Dc-1000U Back-Up; Stop Button Alarm Shut-Off - Elite CSW-200-UL Series Instruction Manual

Bolt-On
Motor
and
Pulley
#3 - N.C.
Stop
Button
Install the stop
button in a secure
accessible place.
Use STOP Button:
• To stop the movement of the gate in case of potential entrapment.
• To reset the audio alarm, (check for obstructions).
• To stop the gate operator while traveling.
When using the Omni option board, use the
32
O P T I O N A L D C - 1 0 0 0 U B A C K U P
DC-1000 Unit
S T O P B U T T O N A L A R M S H U T - O F F
STOP
OPEN CLOSE
1 2 3 4 5
#4 - Com
W4
This is an important command required to stop the audio alarm in case it has
been triggered. Otherwise the alarm will sound for 5 minutes and reset itself.
Option A:
In case of power failure the gate opens
automatically one time and stays open.
When power is restored the operator
returns to normal condition.
Wire
Option B:
Harness
In case of power failure the gate will not
open automatically until activated by a key
switch or push button. Maintain contact
with the switch or push button until gate is
completely open.
Omni Option Board Needed
CENTER SAFETY
6
QCC
W4
A B
G B A
OPEN STOP MS LINK CLOSE MAGLOCK
Cut jumper wire #W4.
"STOP" input to connect the stop button.
For More Details,
ask your Local Dealer
EXIT
SYSTEM ON TIMER
A L ARM ARMED M/ S L INK
SENSORS
60
OFF ON
1 3 1 3
OPEN LEFT OPEN RIGHT
FIRE STRIKE RADIO
DEPT. OPEN RECEIVER LOCKED
EXIT SAFETY CENTER
LOOP LOOP LOOP
DC-BACKUP
POWER
3
OVERLOAD
1 3
MADE IN USA
GATE
RESET
MOTOR