Role Of Specifiers And Designers; Role Of Dealers, Installers And Trained Gate System Technicians - Elite CSW-200-UL Series Instruction Manual

R O L E O F S P E C I F I E R S A N D D E S I G N E R S
Specifiers and designers should design an automatic vehicular gate system to:
• Incorporate UL 325 compliant equipment.
• Utilize an operator suited for gate system type, size, frequency of use, location and user population
(Refer to UL 325 for usage class definitions)
• Separate pedestrian access from vehicle access.
• Reduce or eliminate pinch points.
• Reduce risk of entrapment injuries by minimizing all gaps in the gate and enclosing the area of the
travel of the gate.
• Secure controls from unauthorized use..
• Locate all controls out of reach from the gate.
• Allow the user full view of the gate when operating.
• Consider special populations, such as children or the elderly.
• Conspicuously display all warnings and instructions.
• Be consistent with DASMA's Automatic Gate Opener System Safety Guide.
R O L E O F D E A L E R S , I N S T A L L E R S A N D
T R A I N E D G A T E S Y S T E M T E C H N I C I A N S
Installers, during the course of the installation proceedings for each job, should:
• Confirm that the gate operator being installed is appropriate for the application.
• Confirm that the gate is designed and built according to current published industry standards.
• Confirm that all appropriate features and accessory devices are being incorporated, including both
primary and secondary entrapment protection devices.
• Make sure that the gate works freely before installing the operator.
• Repair or service worn or damaged gate hardware before installing the operator.
• Eliminate all gaps in the sliding gate below a 4 foot height that permit a 2 1/4 inch sphere to pass
through any location, including the area of the adjacent fence covered when the gate is in the open
position.
• Install the gate operator according to the manufacturer's installation instructions.
• Adjust the operator clutch or load-sensing device to the minimum force setting that allows reliable gate
operation.
• Install operator inside fence line (DO NOT install operator on public side of fence line)
• Install a proper electrical ground to a gate operator.
• Install keypad controls where users cannot touch, or reach through gate while operating controls.
• Install controls where user has full view of gate operation.
• Install all warning signs (In accordance with UL 325) on both sides of the gate to warn persons in the
area of potential hazards associated with automatic vehicular gate operation.
• test all features for proper functions before placing the automatic vehicular gate into service.
• Demonstrate the basic functions and safety features of the gate system to owners/end users/general
contractors, including how to turn off power and how to operate the manual disconnect feature.
• Leave safety instructions, product literature, installation manual and maintenance manual with end
user.
• Explain to the owners the importance of a service contract that includes a routine re-testing of the
entire system including the entrapment protection devices, and explain the need for the owners to
insure that this testing is performed routinely.
• Offer the owner/end user a maintenance contract, or contact them regularly to offer maintenance.
6