Optional Dc-100Du Back-Up; Stop Button Alarm Shut-Off - Elite CSW-200-UL series Instruction Manual

Bolt-On
Motor
and
Pulley
OPEN
#3
Stop
Button
1 2
#4
Install the stop
button in a secure
accessible place.
This is an important command required to stop the audio alarm in case it has been
triggered. Otherwise the alarm will sound for 5 minutes and reset itself.
Use STOP Button:
•To stop the movement of the gate in case of potential entrapment.
•To reset the audio alarm, (check for obstructions).
•To stop the gate operator while traveling.
When using the Omni option board, use the "STOP" input to connect the stop button.
DC-1000 Unit
Wire
Harness
STOP
CLOSE
3 4 5 6
W4
Cut off jumper wire #W4.
Option A:
In case of power failure the gate opens
automatically one time and stays open.
when power is restored the operator
returns to normal condition.
Option B:
In case of power failure the gate will not
open automatically until activated by a key
switch or push button.
Contact your Local Dealer
Omni Option Board Needed
CENTER SAFETY EXIT
QCC
W4
A B
G B A
SYSTEM ON
O P E N S T O P C L O S E MAGLOCKALARMARMED M/S LINK MS LINK
SENSORS
1 3
for More Details
DC-BACKUP
TIMER
POWER
60 3
OVERLOAD
1 3
OFF ON
MADE IN USA
1 3
OPEN LEFT OPEN RIGHT
FIRE STRIKE RADIO GATE
DEPT. OPEN RECEIVER LOCKED
EXIT SAFETY CENTER RESET
LOOP LOOP LOOP MOTOR