Victory Motorcycles 2009 Hammer Owner's Manual page 92

Drive Belt
Drive Belt Tension
New drive systems (new belt & sprockets)
After 500 miles on drive system
The following data is provided for use with a Sonic Tension Meter. Follow the instructions provided with the meter.
Required Data
Span
Belt width
Belt mass constant
Internal tooth cracks (hairline):
OK to run, but monitor condition
Fuzzy edge cord:
OK to run, but monitor condition
Drive Belt Deflection (with 10 lbs. of force)
658.3mm
28mm
8.4
Drive Belt Wear Analysis
External tooth cracks:
Replace belt
Hook wear:
Replace belt
10mm +/-- 0.5mm
12mm +/-- 0.5mm
Required Data
Tension (new belt)
Tension (after 500 miles)
Missing teeth:
Replace belt
Stone damage:
Replace belt if damage is on edge
MAINTENANCE
35.7 Hz +/-- 1
32.3 Hz +/-- 1
Chipping (not serious):
OK to run, but monitor condition
Bevel wear (outboard edge only):
OK to run, but monitor condition
87