Starting The Engine - Victory Motorcycles 2009 Hammer Owner's Manual

Starting the Engine

The VICTORY motorcycle has a starter interlock system. The engine can be started only when the transmission is
in neutral or when the transmission is in gear and the clutch is disengaged (clutch lever is pulled in).
Follow these steps to start the motorcycle:
1. Perform the Pre-Operation Check as outlined beginning on page 47. If you're carrying cargo, inspect the cargo
restraints for tightness.
2. Insert the ignition key into the ignition switch and turn the switch to the ON position (see page 35).
3. Mount the motorcycle and bring it to an upright position. Engage the front brake and place the sidestand in the
stored (up) position. If the neutral indicator is not illuminated, shift the transmission to neutral (see Shifting
Gears, page 67).
4. Set the engine stop/run switch to the RUN position. You should hear the fuel pump run momentarily as it
pressurizes the fuel system.
NOTE: If the motorcycle was run completely out of fuel, prime the system as instructed on page 64.
(Continued on next page)
OPERATION
65