Victory Motorcycles 2009 Hammer Owner's Manual page 89

MAINTENANCE
Engine Oil
Engine Oil Level
1. With the transmission in neutral, start and run the engine for several
minutes.
2. Shut the engine off and wait for 3-5 minutes.
3. With the engine at normal operating temperature, straddle the
motorcycle on level ground and bring it to a vertical position. Remove
the oil fill cap and wipe the dipstick clean. Reinstall the dipstick and
turn the cap clockwise until it seats.
4. Remove the dipstick again and note the oil level.
5. If necessary, add or remove oil to bring the level into the area on the
dipstick, above the ADD mark and below the FULL mark (see page
50). Repeat steps 1-2 each time you adjust the oil level.
WARNING
Do not operate the motorcycle with the oil level above the FULL mark or below the ADD mark. Operating
the engine with too much or too little oil can cause serious engine damage or engine seizure, resulting in
loss of control of the motorcycle.
84
1
2 3
1. Oil Fill Cap/Dipstick
2. ADD Mark
3. FULL Mark