Ap 7161 Grounding Screw; External Hardware Reset Button - Motorola AP 7161 Installation Manual

16

AP 7161 Grounding Screw

The grounding screw is located to the right of the GE1/POE port and above the GND symbol.
WARNING!
The grounding cable can be attached to the unit using one of three recommended methods. Using an 8mm socket and driver:
Loosen the grounding screw and insert the grounding cable into the hole below it. Tighten the grounding screw to between
•
21.9 and 29.2 inch pounds (lbf-in).
Loosen the grounding screw and wind the grounding cable around the screw. Tighten the grounding screw to between
•
21.9 and 29.2 inch pounds (lbf-in).
Attach a ring lug to the grounding cable and remove the grounding screw to attach the ring lug to the access point. Secure
•
it to the unit by reinserting the grounding screw. Tighten the grounding screw to between 21.9 and 29.2 inch pounds
(lbf-in).

External Hardware Reset Button

NOTE
An AP 7161 can be physically reset using the hardware reset button. The button is located inside the reset port on the bottom of
the unit.
The reset button is only enabled for a ten second interval as the unit boots up. It can be accessed by removing the cover screw
using a rachet driver and a #2 Phillips head adapter. Push the button to reset the access point. Confirm that the reset cycle was
completed and replace the cover screw.
To perform an external hardware reset and restore the access point default settings:
Using a #2 phillips screwdriver, remove the cover screw from the external reset port.
1.
Gently press and hold the reset button.
2.
If any of LEDs 2 through 6 are active, it indicates that the unit has booted successfully and the operational software is
3.
running.
The grounding cable for an AP 7161 must be a #10 gauge wire cross section.
This option is supported by software. Please refer to the release notes for the appropriate software
to check for availability.
AP 7161 Access Point Installation Guide