Motorola AP 7161 Installation Manual page 27

AP 7161 Access Point Installation Guide
Use a torque wrench or a ratchet and a 10mm socket to finish attaching the angle adapter bracket section to the access point
5.
bracket section with the four M6 hex flange screws in the open slot connections and the top holes on the angle adapter
bracket section. Do not tighten the screws until all rotation and tilt adjustments are complete
To adjust the position of the access point, rotate the access point bracket section (plus or minus 15 degrees) and tilt the angle
6.
adapter bracket section (up to 45 degrees).
Tighten all hex flange screws to 60 inch pounds (lbf-in).
7.
To use only the extension arm:
Using four #10/32 lag bolts, attach the extension arm at the desired mounting location.
1.
Using a torque wrench or a ratchet and a 10mm socket, attach the mounting extension arm to the access point with four M6
2.
hex flange screws. Tighten the hex flange screws to 60 inch pounds (lbf-in).
To use the extension arm with the mounting hardware kit:
With the open slot connections facing down, attach the angle adjust bracket section at the desired mounting location using
1.
four #10/32 lag bolts.
Complete the steps for assembling and positioning the angle adapter and access point mounting bracket sections outlined
2.
above.
With the access point positioned so that the gore vent is facing down, attach the extension arm to the access point bracket
3.
section of the assembled mounting bracket already in position using four M6 hex flange screws. Tighten the hex flange
screws to 60 inch pounds (lbf-in).
Using a torque wrench or a ratchet and a 10mm socket, attach the extension arm to the access point with four M6 hex flange
4.
screws. Tighten the hex flange screws to 60 inch pounds (lbf-in).
27