Motorola AP 7161 Installation Manual page 24

24
To adjust the position of the access point, rotate the access point bracket section (plus or minus 15 degrees) and tilt the angle
11.
adapter bracket section (up to 45 degrees).
Tighten all hex flange screws to 60 inch pounds (lbf-in).
12.
For poles greater than 3 inches in diameter:
Attach the pole mount bracket section at the desired mounting location using band clamps.
1.
With the angle adapter bracket section positioned so that the open connector slots are on the bottom, attach the angle
2.
adapter bracket section to the pole mount bracket section using two 1/2 inch bolts and nuts. Tighten the nuts to 300 inch
pounds (lbf-in).
Position the access point bracket section so that the bottom of the section with the straight (not bevel cut) sides is oriented
3.
toward the bottom side of the AP with the gore vent. Using a torque wrench or a ratchet and a 10mm socket, attach (but don't
tighten) the access point bracket section to the AP 7161 with the with four M6 hex flange screws.
Insert two M6 hex flange screws into the bottom holes on the sides of the access point bracket section.
4.
With the access point positioned so that the gore vent is facing down, insert the two M6 hex flange screws in the bottom holes
5.
on the sides of the access point bracket section into the open slot connections on the bottom of the angle adapter bracket
section.
AP 7161 Access Point Installation Guide