Extreme Flight 50cc Edge 540T ARF Instruction Manual page 5

Elevator
1. Locate the horizontal stabilizer/elevator assemblies as well as the composite control
horns and base plates from the elevator hardware package. Use a sharp #11 blade to
make a cut in the covering over the 2 slots for the elevator control horns on the bottom of
the elevator surface. Double check to make sure you are cutting into the bottom of the
elevator.
2. Insert the 2 control horns into the base plate and trial fit the horns into the slot and
make sure they seat properly against the base and elevator surface. Trace around the
base plate with a felt tipped marker.
5