Advertisement
17. When satisfied with the position of the wheel pants, drill a hole though the plywood
plate that is glued inside the pant at the location of the hole in the landing gear. Secure
the pant in position with the provided 3mm bolt and blind nut. Repeat this process for the
remaining wheel pant.
18. While the Edge is still upside down let's install the rudder and the tailwheel assembly.
As you did with the ailerons and elevators, glue the hinges into the rudder first with epoxy
and allow to cure. Use a pushrod to apply epoxy to the holes in the rudder post and push
the rudder into position and wipe away any excess epoxy with a paper towel and
denatured alcohol.
20
Advertisement
