Advertisement
23. Install your rudder servo using the supplied hardware with the output shaft toward
the front of the plane. We used the Hitec 5955 and Hitec 7955 in our prototypes with great
results. I highly recommend a servo with 280+ ounce inches of torque for best results.
We are using the SWB 4" offset rudder arm. We highly recommend the use of this quality
product to ensure correct geometry.
24. Next let's install the pull-pull rudder cables. Look at the rear of the fuselage just above
the horizontal stabilizer location and you will find the location of the pull-pull cable exit
slot. Use a sharp hobby knife to remove the covering from this slot on each side of the
fuselage.
24
Advertisement
