Service Interval Display; Fig - Skoda Octavia Owner's Manual

Škoda octavia
Hide thumbs Also See for Octavia:
Table of Contents

Advertisement

Abort lap - Cancel the timer (the aborted lap time is not stored)
Hang up - End timing (the aborted lap time is stored)
Evaluate recorded times
Select the menu item Lap timer - Statistics.
The following information is displayed.
Fastest: - The fastest lap
Slowest: - The slowest lap
Average: - The average lap time
Overall time: - The total of all the lap times
Reset measured times
Select the menu item Lap timer - Statistics - Reset.
WARNING
Concentrate fully at all times on your driving! As the driver, you are fully re-
sponsible for the operation of your vehicle.
Only use the Lap timer system when you are in any traffic situation where
you have full control over the vehicle.
Note
The system allows the measurement of up to 11 lap times.
The measurement of single lap time is stopped after 99 h, 59 min and 59 sec.
After this time has been reached, measuring the new lap starts automatically.
The measured times cannot be reset individually.
If the measured times are not reset, then these are stored even after turning
off the ignition.

Service interval display

Introduction
This chapter contains information on the following subjects:
Service messages
Resetting Service Interval Display
The service due date is automatically displayed on the display and this informa-
tion can be displayed manually at any time if necessary.
Note
Information is retained in the Service Interval Display even after the vehicle bat-
tery is disconnected.
If the instrument cluster is exchanged after a repair, the correct values must be
entered in the counter for the Service Interval Display. This work is carried out by
a specialist garage.
In some national versions the displays appear in the Imperial system of meas-
urement.
For more information on the service intervals, see
Service messages
First read and observe the introductory information given on page 33.
Messages before reaching the scheduled service date
Before reaching the service date, the icon  appears in the display after the igni-
tion is switched on, as well as the following message for example.
Oil change in ... days
OIL CHANGE IN ... DAYS
or
Inspection in ... days
INSPECT_ IN ...DAYS
The kilometre indicator or the days indicator reduces in steps of 100 km or, where
applicable, days until the service due date is reached.
Messages upon reaching scheduled service date
Once the service interval is reached, the icon  appears in the display after the
ignition is switched on, as well as the following message for example.
Oil change now!
OIL CHANGE NOW
or
33
Inspection now!
34
INSPECTION NOW
or
» page
198, Service intervals.
33
Information system

Advertisement

Table of Contents
loading

Table of Contents