Skoda Octavia Owner's Manual page 155

Start control

First read and observe the introductory information and safety warn-
ings on page 148.
Basic requirements for start of control
ACC is enabled.

TCS is enabled » page 137, Brake assist systems.

On vehicles with a manual transmission, the second gear or higher must be

engaged.
On vehicles with a manual transmission, the current speed must be higher

than approx. 25 km/h.
On vehicles with an automatic transmission, the selector lever must be in the

D/S position or in the Tiptronic position.
On vehicles with an automatic transmission, the current speed must be high-

er than approx. 2 km/h.
The control be started with the key  or by adjusting the lever into the sprung
position  » Fig. 138 on page 151 .
Button 
›
Press  the key.
The ACC will take over the current speed and executes control.
Lever position 
›
Set the lever into the sprung position  .
The ACC will take over the current speed and executes control. Should the speed
be stored already, the ACC adopts this speed and executes control.
If control is enabled, the green indicator light
bar.
Note
If control is started at a speed of less than 30 km/h on vehicles with an auto-
■
matic transmission, the speed of 30 km/h is stored. The speed increases auto-
matically to 30 km/h or is regulated with respect to the speed of the vehicle
ahead.
When TCS is disabled, it will be activated automatically upon starting control.
■
If the TCS is deactivated during control, control is stopped automatically.
■
152
Driving
illuminates in the warning light

Stop/resume control

First read and observe the introductory information and safety warn-
ings on page 148.
Stop control
›
Set the lever into the sprung position 
or
›
Apply the brake.
Control stops, the speed remains stored.
Resume control
›
Start control » page 152.
Note
Control is also stopped when the clutch is held down for longer than 30 s.
Set/change the desired speed

First read and observe the introductory information and safety warn-
ings on page 148.
The desired speed can be set or changed using the control
The set speed is stored upon releasing the lever or the button on the button on
the lever.
Set/change speed by 10 km/h at a time) - Requirements
ACC is enabled.

Increase speed by 1 km/h at a time () - Requirements
ACC is enabled.

Vehicle control ensues.

Decrease speed by 1 km/h at a time () - Requirements
ACC is enabled.

Vehicle control ensues.


» Fig. 138 on page 151 .
lever» page 151.

