Coolant - Skoda Octavia Owner's Manual

Replenishing

First read and observe the introductory information and safety warn-
ings on page 219.
›
Check the oil level » page 220.
›
Unscrew the cap of the engine oil filler opening
›
Replenish the oil in portions of 0.5 litres in accordance with the correct specifi-
cations » page 219.
›
Check the oil level » page 220.
›
Carefully screw on the oil filler opening cap and push the dipstick in fully.
Changing

First read and observe the introductory information and safety warn-
ings on page 219.
The engine oil must be changed according to prescribed service inter-
vals » page 198 or according to the service interval display

Coolant


Introduction
This chapter contains information on the following subjects:
Capacity
Checking the coolant level
Replenishing
The coolant consists of water with a concentration of coolant additive. This mix-
ture guarantees antifreeze protection, protects the cooling/heater system
against corrosion and prevents the formation of scale.
Vehicles exported to countries with a mild climate are already factory-filled with
a coolant which offers antifreeze protection down to about -25 ℃. In these coun-
tries the concentration of coolant additive should be at least 40 %.
Vehicles exported to countries with a cold climate are already factory-filled with a
coolant which offers antifreeze protection down to about -35 °C. In these coun-
tries the concentration of coolant additive should be at least 50 %.
» Fig. 182 on page 218.

» page 33.

222
222
222
If a higher concentration of antifreeze is required for climatic reasons, the amount
of coolant additive can only be increased up to a maximum of 60 % (antifreeze
protection down to approx. -40 °C).
When refilling, only use antifreeze with the name specified on the coolant expan-
sion tank » Fig. 185 on page 222.
WARNING
The engine compartment of your car is a hazardous area. While working in
■
the engine compartment, be sure to observe the following warn-
ings » page 215.
Do not continue your journey, if for some reason it is not possible to top
■
up the coolant under the prevailing conditions! Switch off the engine and seek
assistance from a specialist garage.
CAUTION
The amount of coolant additive in the coolant must never be allowed to be less
■
than 40 %.
Over 60 % of coolant additive in the coolant reduces the antifreeze protection
■
and coolant effectiveness.
A coolant additive that does not comply with the correct specifications can sig-
■
nificantly reduce the corrosion protection.
Any faults resulting from corrosion may cause a loss of coolant and can conse-
■
quently result in major engine damage!
Do not fill the coolant above the mark
■
If a fault causes the engine to overheat, we recommend visiting a specialist ga-
■
rage, as otherwise serious engine damage may occur.
» Fig. 185 on page 222.
A
Inspecting and replenishing

221