Skoda Octavia Owner's Manual page 236

WARNING
Never use the temporary spare wheel if it is damaged.
■
If the dimensions or design of the temporary spare wheel differ from the fit-
■
ted tyres, never drive faster than 80 km/h (or 50 mph).
Avoid accelerating at full throttle, sharp braking and fast cornering.
■
CAUTION
Observe instructions on the warning sign of the emergency wheel.
Full wheel trim

First read and observe the introductory information and safety warn-
ings on page 228.
Extracting
›
Hook the clamp found in the vehicle tool kit into the reinforced edge of the
wheel trim.
›
Push the wheel wrench through the clamp, support on the tyre and pull off the
wheel trim.
Installing
›
Press the wheel trim onto the wheel rim at the valve opening provided.
›
Then press the trim into the wheel rim until its entire circumference locks cor-
rectly in place.
CAUTION
Use the pressure of your hand only, do not strike the full wheel trim. Avoid
■
heavy knocks when the trim is not yet inserted in the wheel rim. This could cause
damage to the guide and centring elements of the trim.
When using the anti-theft wheel bolt, ensure that it is in the hole in the valve
■
area » page 240, Securing wheels against theft.
If wheel trims are retrofitted it must be ensured that an adequate flow of air is
■
assured to cool the brake system.
Wheel bolts


First read and observe the introductory information and safety warn-
ings on page 228.
Extracting
›
Push the extraction pliers » page 236
ner catches of the pliers are positioned at the collar of the cap
›
Remove the cap.
Installing
›
Push the caps onto the wheel bolts up to the stop.
The wheel bolt caps are housed in a plastic box in the spare wheel or in the stor-
age space for the spare wheel.
Wheel bolts

First read and observe the introductory information and safety warn-
ings on page 228.
Wheels and wheel bolts are matched to each other in terms of design. Each time
you fit other wheels, e.g. light alloy wheels or wheels with winter tyres, you must
also use the matching wheel bolts of the correct length and shape of spherical
cap. This is a prerequisite for ensuring that wheels are attached correctly.

Fig. 193
Remove the cap
sufficiently far onto the cap until the in-
» Fig. 193.
Wheels


233