WARNING
Check that the crossbar of the net partition is hung firmly into the recepta-
■
cles
» Fig. 101
on page 102 and
D
The belts and the belt locks must be in their original position after folding
■
back the seat backrests – they must be ready to use.
The seat backrests must be securely locked in position so that no objects in
■
the luggage compartment can slide into the passenger compartment on sud-
den braking – risk of injury.
Ensure that the rear seat backrests are properly engaged. Only then can the
■
seat belt for the middle seat reliably fulfil its function.
Using the net partition behind the rear seats
Fig. 101 Folding out part of the roll-up luggage compartment cover/net par-
tition behind the rear seats in the pulled-out state
102
Using the system
» Fig. 103
on page 103.
C
Fig. 102
Net partition: Release lever
First read and observe the introductory information and safety warn-
ings
on page 101.
Extending
›
Fold out part of the roll-up luggage compartment cover
the arrow
» Fig.
101.
›
Pull out the net partition at the upper crossbar
›
Hook the crossbar into one of the receptacles
›
On the other side, press on the crossbar and hook it into the appropriate recep-
tacle
.
D
If the cross-bar is hooked into the receptacle
cross bar in the direction of arrow 1 and insert into the receptacle to the right
›
Fold back part of the roll-up luggage compartment cover
rection of the arrow.
Retracting
›
Fold out part of the roll-up luggage compartment cover
the arrow
» Fig.
101.
›
Press on the crossbar and remove it from the receptacles
then on the other side.
›
Hold the crossbar
in such a way that the net partition can slowly roll up into
B
the housing
without being damaged.
C
›
Fold back part of the roll-up luggage compartment cover
rection of the arrow.
CAUTION
If the net partition blocks when pulling it out of the housing, push the release lev-
er
in the direction of the arrow
E
Note
If you wish to use the entire luggage compartment, the roll-up luggage compart-
ment cover can be removed
» page
in the direction of
A
from the housing
B
.
D
for example, the press on the
D
in the opposite di-
A
in the direction of
A
, first on one side,
D
in the opposite di-
A
» Fig.
102.
96.
.
C
.
D